Manual

Thank you for showing your condence in us by purchasing the
Behringer ULTRA METAL UM300. This high-quality eects pedal comes
with a dual-gain circuitry that enables you to produce super thick, tube-
like distortion plus endless sustain. Thanks to its high-performance
features you will achieve the most extreme and sought-after hard rock
or heavy metal distortion sounds.
1. Controls
(1) The LOW control allows yu to boost/cut the lo-frequency range.
◊◊ Please keep in mind that extrme distortion and EQ
settings will increase nose and may induce oscillation.
(2) The two MID FREQ(uency) controls allow to boost/cut a dè ned
mid-frequency range. The upper control is used to increase
or lower the mid range, the cntrol below adjusts the center
frequency of the mid range that is aected (200 Hz to 5 kHz).
(3) The LEVEL control adjusts the output level.
(4) The ON/BATT LED illumnates when the eect is activated. It also
serves as a battery leve indicator.
(5) Use the footswitch to activate/deactivate the eect.
(6) Use this ¼" TS IN connector to plug in the instrument cable.
(7) The ¼" TS OUT connector sends the signal to your amp.
Use the DC IN connection to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover.
To install or replace the 9 V battery, press the hinges with a ballpen and
remove the pedal cover. Be careful not to scratch the unit.
V1.0
ULTRA METAL UM300
Heavy Metal Distortion Eects Pedal
(3)
(1)
(5)
(4)
(7)
(2)
(8)
(6)
(9)