V-AMP® Version 1.
V-AMP 2 SAFETY INSTRUCTIONS CAUTION: To reduce the risk of electric shock, do not remove the cover (or back). No user serviceable parts inside; refer servicing to qualified personnel. WARNING: To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. This symbol, wherever it appears, alerts you to the presence of uninsulated dangerous voltage inside the enclosure—voltage that may be sufficient to constitute a risk of shock.
V-AMP 2 FOREWORD Dear Customer, Welcome to the community of BEHRINGER users and thank you for the trust you have shown us in buying the V-AMP 2. It gives me particular pleasure to write this to you because, after months of hard work, our engineers have achieved a highly ambitious goal: to improve on what is already an excellent virtual guitar amp whose highly developed sound and remarkable array of functions offers you maximum flexibility and performance.
V-AMP 2 V-AMP® Virtual guitar amplifier with tube simulation and digital multi-effects processor V-AMP V Authentic virtual guitar preamp with 32 amp and 15 speaker simulation models V Dedicated selectors for amp models, speaker cabinets and digital effects V Transparent user interface with direct display of all essential settings V 32 simulations of popular guitar amps, ranging from clean to crunch to tube distortion sounds V 15 speaker simulations directly selectable and freely combinable with any amp
V-AMP 2 TABLE OF CONTENTS 1. INTRODUCTION ......................................................................................................................6 1.1 The new functions of the V-AMP 2 ................................................................................................. 6 1.2 Before you begin ............................................................................................................................ 7 1.2.1 Serial number ............................................
V-AMP 2 1. INTRODUCTION Congratulations! The V-AMP 2 you have purchased is the revised version of the V-AMP—a state-of-the-art virtual guitar amplifier that has set new standards. Our ultimate aim in developing it was to create the authentic sound of classic amplifiers by means of “physical modeling” and to combine this with the latest DSP effects.
V-AMP 2 1.2 Before you begin Your V-AMP 2 was carefully packed before it left the factory to protect it from damage in transit. If there are signs of damage on the packaging, we recommend that you immediately examine the device itself for further signs of damage. In case of damage, do NOT return this device to us, but immediately notify your dealer and the transport company, as any entitlement to damages may otherwise be lost.
V-AMP 2 1 The MASTER control determines the overall volume of the V-AMP 2. Apart from the AUX LEVEL control this is the only “conventional” control on the V-AMP 2. All the other controls are encoder-type rotary controls. 2 The VOLUME control is for the volume of the selected preset. 3 The BASS control in the EQ section is for raising or lowering the low-frequency range. 4 The MID control is for raising or lowering the mid-range frequencies.
V-AMP 2 10 This control is for selecting an effect or a combination of effects. This encoder-type rotary control is also surrounded by a ring of 16 LEDs. Each LED corresponds to one specific effects preset. 11 Using the REVERB control, you can add the reverb content of your choice to your overall sound. By turning it to the left until all the LEDs are off, you deactivate the reverb. To fade out the original signal, turn the control to the right until only the last LED lights up.
V-AMP 2 18 Connect the enclosed power supply unit via the AC IN socket. 19 The balanced LINE OUT 1/4" sockets provide the audio signal from the V-AMP 2 in stereo, for example, for recording purposes. You can connect the LINE OUT outputs with balanced or unbalanced jack plugs. The left line output of the V-AMP 2 can be used to route the audio signal to a guitar amp with a mono input. Please note that the signal from the multi-effects processor will then not be available in stereo either.
V-AMP 2 In modes L1, L2 and L3, the additional 3-band EQ is set with the BASS, MID and TREBLE controls. As this EQ works globally, it has no effect on the settings of these three controls from the preset programming. If you plug in your headphones, the V-AMP 2 automatically selects S1 mode. 2.1 Selecting CONFIGURATION modes Your V-AMP 2 left the factory set in Studio 1 (S1) mode. To change modes, you have to switch to CONFIGURATION mode. To do this, press buttons B and D simultaneously.
V-AMP 2 2.3 Recording A widely used recording application is to make a “dry” recording of the output signal while monitoring the signal with effects (“wet”). The advantage here is that you don’t have to make a final decision on what effect to use during mix-down. For this purpose connect the left output of the V-AMP 2 to the recording device, and use the right output for monitoring. If you have a MIDI foot controller, you can use it to control preset, bank and amp model changes.
V-AMP 2 For this application please select mode L1 or L2 under CONFIGURATION, depending on whether you want to have the external amp with or without cabinet simulation! Thus, you can also optimize the sound on the amp with TREBLE, MID and BASS of the global 3-band EQ. 2.5 Live set-up with P.A. system and your own monitor amp on stage This application is intended to give you your own guitar signal on stage so that you can have complete control of intentionally produced feedback, for example.
V-AMP 2 Fig. 3.1: Calling up presets In this case, by pressing button A, B, C or E you can immediately call up another preset of the same bank. The two arrow keys (BANK UP und BANK DOWN) enable you to switch banks. The display on the V-AMP 2 always shows which bank has been selected. When you switch banks, the preset has to be called up by pressing one of the buttons A - E. An LED lights up to show you which preset in the respective bank has been activated. 3.
V-AMP 2 preset the temporary edited version is discarded. However, after editing you can also hold down the two arrow keys until “Pr” appears in the display, which brings back the factory preset that was originally stored there. However you then have to save it again by holding down the corresponding preset button for approx. two seconds. 3.
V-AMP 2 amazingly distorted sound even at low volume. The Tweed Champ had a volume control, but no EQ control. If you want to get the most authentic sound out of this amp, keep the sound control on the V-AMP 2 in the midrange. CLASSIC CLEAN: Back in the 80s, the Roland JC-120 was the preferred sound of Buzzy Feiten (guitarist with the Dave Weckl Band). The unique quality of this transistor amp’s sound is the way its brilliance cuts through any mix.
V-AMP 2 The unique feature of the Savage is its extreme power and is therefore highly popular with heavy metal guitarists. Silent Force/Sinner guitarist Alex Beyrodt has been an enthusiastic Engl user for years. An amp for making yourself heard! FUZZ BOX: This sound is not actually based on any one amp, but on a particular fuzz box. Jimi Hendrix was one of the first guitarists to recognize the potential in this legendary broadband transistor distortion.
V-AMP 2 No. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Cabinets Configuration BYPASS (NO SPEAKER-SIMULATION) 1 x 8" VINTAGE TWEED 4 x 10" VINTAGE BASS 4 x 10" V-AMP CUSTOM 1 x 12" MID COMBO 1 x 12" BLACKFACE 1 x 12" BRIT '60 1 x 12" DELUXE '52 2 x 12" TWIN COMBO 2 x 12" US CLASS A 2 x 12" V-AMP CUSTOM 2 x 12" BRIT '67 4 x 12" VINTAGE 30 4 x 12" STANDARD '78 4 x 12" OFF AXIS 4 x 12" V-AMP CUSTOM Tab. 4.1: Cabinets on the V-AMP 2 5.
V-AMP 2 To match speed-based effects to the tempo of the music, please press the TAP button twice in time to the music. 5.1 Effect descriptions The following section contains short descriptions of the effects that can be produced using the multi-effects processor in your V-AMP 2. Reverb and delay algorithms REVERB: Reverb is still the most important effect for mixing or live performance.
V-AMP 2 Special effects COMPRESSOR: A compressor limits the dynamic range of the audio material, thus producing audible and creative sound effects. Pronounced use of the compressor (using the EFFECTS control) allows you to compress the overall dynamic range of the material. AUTO-WAH: The legendary wah-wah effect owes its fame mainly to Jimi Hendrix. Describing it is certainly more difficult than simply listening to Hendrix using it on Voodoo Chile.
V-AMP 2 6. TUNER Press the TUNER button to activate the built-in tuner. 6.1 Tuning your guitar The chromatic tuner automatically recognizes the frequencies of all the standard guitar notes. For the A-string this means a frequency of 220 Hz. When you plug your guitar into the V-AMP 2 and play an open string, the tuner will recognize and display the note. Since the tuner uses an auto-chromatic scale, it can also recognize semi-tones, which are shown with a “b” in the display.
V-AMP 2 7. INSTALLATION 7.1 Audio connections The input of your BEHRINGER V-AMP 2 is a mono 1/4" jack. The Line Out, Aux In and headphones outputs are stereo 1/4" jacks. The Line Out outputs work with both balanced and unbalanced connections. Fig. 7.1: Comparison of different plug types Fig. 7.2: Wiring of a stereo headphones 1/4" plug 22 7.
V-AMP 2 7.2 MIDI connections The MIDI standard (Musical Instruments Digital Interface) was developed in the early 80s to enable different makes of electronic instruments to communicate with each other. Over the years the range of MIDI applications has constantly expanded, and today it is standard practice to network entire recording studios using the MIDI standard.
V-AMP 2 8. APPENDIX 8.
V-AMP 2 8.2 Default cabinets/amp models 1st level name # default cabinet simulation 2nd level name # default cabinet simulation AMERICAN BLUES 2 4 x 10" VINTAGE BASS AND DELUXE 2 4 x 10" VINTAGE BASS MODERN CLASS A 9 2 x 12" US CLASS A CUSTOM CLASS A 9 2 x 12" US CLASS A TWEED COMBO 1 1 x 8" VINTAGE TWEED SMALL COMBO 1 1 x 8" VINTAGE TWEED CLASSIC CLEAN 8 2 x 12" TWIN COMBO BLACK TWIN 8 2 x 12" TWIN COMBO BRIT. BLUES 12 4 x 12" VINTAGE 30 AND CUSTOM 12 4 x 12" VINTAGE 30 BRIT.
V-AMP 2 9. SPECIFICATIONS AUDIO INPUTS Guitar input Input impedance Aux inputs Input impedance 1/4" mono phone jack, unbalanced approx. 1 MΩ 1/4" stereo connector, balanced approx. 50 kΩ AUDIO OUTPUTS Line outputs Output impedance S/N ratio Headphones 1/4" stereo connector, balanced approx. 2 kΩ 90 dB @ preamp bypass 1/4" stereo phone jack MIDI INTERFACE Type 5-pos. DIN jacks IN / OUT DIGITAL PROCESSING Converters Sampling rate DSP Delay time 24-Bit Delta-Sigma, 64/128 oversampling 31.
V-AMP 2 10. WARRANTY § 1 WARRANTY CARD/ONLINE REGISTRATION To be protected by the extended warranty, the buyer must complete and return the enclosed warranty card within 14 days of the date of purchase to BEHRINGER Spezielle Studiotechnik GmbH, in accordance with the conditions stipulated in § 3. Failure to return the card in due time (date as per postmark) will void any extended warranty claims.
