User Manual

33 X32 RACK DIGITAL MIXER User Manual
7.1.3 Navigation Methods
Following is an overview of how to navigate to the dierent console screens,
screen tabs, and sets of encoder parameters.
1. Press any of the 10 hardware buttons located on either side of the main
display screen.
2. On any given screen, press the Page Select left/right keys to navigate among
the various screen “tabs” within a screen category.
3. On any given screen, press the Layer up/down keys to navigate among the
various sets of encoder parameters located at the bottom of each screen.
Rotary Encoder Elements:
Gain
dB
+0.00
Link
Lo Cut
Hz
20
Lo Cut
Input
Select
Source
PRE
Insert
Ins Pos
InsF
Connect
Insert
ms
0.3
Delay
Delay
The bottom of most screens contain 6 slots of information that are always paired
with the 6 hardware rotary encoders located directly underneath each slot.
Thehardware encoders are used to adjust parameters displayed in these slots,
and operate in the following manner:
1. Parameters displayed in the top half of each slot are most often “continuous
type parameters, and are adjusted by rotating the corresponding encoder
located directly below the bottom of the screen.
• For example, in the “home” tab of the Home screen, the “gain”
parameter of the selected input (located in slot 1) is adjusted with the
rst encoder.
2. Parameters displayed in the bottom half of each slot (outlined in dark grey)
are most often “on/o” style parameters, and are adjusted by pushing the
encoder inward, using it as a button.
• For example, in the “home” tab of the Home screen, the “link”
parameter of the selected input (located in slot 1) is adjusted with the
rst encoders push action.
3. If a given screen contains more parameters than ts into the 6 slots, thena
2nd set of slots is made available. Navigate to the next set of slots by
pressing the Layer down key, and the bottom-of-screen content will change
to display the next set of 12 parameters to be adjusted. Press the Layer up
key to return to the original set of 12 parameters.