Quick Start Guide
Table Of Contents
- Important Safety Instructions
- FCC INFORMATION U.S.A.
- 1. Introduction
- 2. Installation
- 3. Connector Plate
- 4. Connection Scenarios
- 5. X32 Setup
- 2. Instalación
- 3. Placa de Conectores
- 4. Posibles Conexiones
- 5. Configuración X32
- 2. Installation
- 3. Plaque Avant
- 4. Exemples de Connexions
- 5. Configuration X32
- 2. Installation
- 3. Anschlussplatte
- 4. Anschluss-Szenarien
- 5. X32 Einrichten
- 2. Instalação
- 3. Placa Conectora
- 4. Situações de Conexões
- 5. X32 Instalação
- Specifications
- 1. Introduction
- FCC INFORMATION U.S.A.
FEDERAL COMMUNICATIONS
COMMISSION COMPLIANCE
INFORMATION
Responsible Party Name: MUSIC Group Services NVInc.
Address: 5270 Procyon Street
Las Vegas, NV 89118
USA
Phone Number: +1 702 800 8290
DIGITAL MIXER OPTION X-ADAT
complies with the FCC rules as mentioned in the followingparagraph:
This equipment has been tested and found to comply with the limits for a
ClassB digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning
the equipment o and on, the user is encouraged to try to correct the
interference by one or more of the followingmeasures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected
• Consult the dealer or an experienced radio/TV technician forhelp
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
Important information:
Changes or modications to the equipment not expressly approved by
MUSIC Group can void the user’s authority to use the equipment.
DIGITAL MIXER OPTION X-ADAT
29Quick Start Guide