User's Manual

fig.c1
fig.c2
fig.c3
Safety
16
C) Circulation (fig. c1):
D check the victim’s pulse (fig. c1)
D if absent, start cardiac massage (fig. c2)
D compress the chest every 1.5 − 2 seconds
D if a rescuer is present, perform 15 compressions in approximately 80 seconds, + 2
quick blows
D if there are two rescuers, perform 5 compressions in approximately 60 seconds, + 1
quick blow (fig. c3)
WARNING:
Do not interrupt the rhythm of compressions when the second person is performing artifi-
cial respiration.
2.2.2.2 If the victim is responsive
D cover the victim with a blanket
D keep them as calm as possible
D loosen their clothing and place them in a reclining position
WARNING:
CALL FOR MEDICAL ASSISTANCE AS SOON AS POSSIBLE IN ALL CASES
2.3 Workplace characteristics
2.3.1 Room characteristics
In order to work freely on the equipment and to be able to perform the relative installation
or maintenance operations, it is necessary to keep a minimum distance from the walls on
all sides of the machine.
The room must be equipped with an appropriate system of clean and dust−filtered air ven-
tilation with a flow rate suitable for the characteristics of the equipment operating in the
room itself.
Outgoing exhausted air must be conveyed directly outside. If the duct’s length or size is
such to presume it may be causing a consistent loss of load to the air flow rate it is neces-
sary to add an extraction apparatus. At the conveyor’s outlet intrusion protection devices
must be provided against insects or other kinds of animals and suitable precautionary
measures against liquid or other materials intrusion must be applied.
The equipment can operate properly if the temperature ranges from −5
o
C to +45
o
C (23
o
F
to 113
o
F), with 95% RH non−condensing at +40
o
C (104
o
F).
2.3.2 Electrical system features
The electrical network installation has to be set in accordance with the regulations in force.
The power supply network must allow an appropriate power provision according to the
laws in force in the Country of installation on the quality of the electrical energy supply
service.
It is highly recommended to use a transformer/network separator and a reduction network
for discharging high voltage.