User's Manual

User instructions
64
The RF input power level is correct.
DescriptionMessageCodeEvent
Mains voltage too high.
VDS voltage is more than 4V different from the
expected value. The adjustment is fixed at the
last valid value. It restarts when the difference
becomes less than 4V.
The internal refer. voltage is no longer reliable
and the measurements will be incorrect. Some
wrong alarms or warnings could be sent.
External reference (10Mhz) absent.
The RF input power level is to low but not dan-
gerous and must be increased.
The MPX input level has remained lower than
the minimum set level for the set time.
The RF input power level is to high but not dan-
gerous and should be decreased.
The AES/EBU input level has remained lower
than the minimum set level for the set time.
RF input power level out of limit. The external
modulator has been disconnected.
The STEREO inputs level is lower than the
minimum set level for the set time.
No sufficient level audio streaming signal for
the set time.
No sufficient level digital MPX audio signal for
the set time.
The CPU backup battery is low. In case of no
mains, the clock will lose settings.
Fan no.3 has stopped working properly.
The clock says a wrong time; it isn’t possible
to cerrect automatically. Some settings, such
as “clock power target”, will not run correctly.
The user has updated the internal clock.
The apparatus has updated the internal clock
automatically.
Audio clipper protection has been activated to
prevent a frequency deviation excess.
Audio clipper protection no longer actives.
The internal time reference has been updated
via NTP server.
052 PSU MAINS OVER VOLTAGE
053
PILOT PWR GOOD
(Amplifier)
053
EXT REF MISSING
(Exciter)
054
INCREASE PILOT PWR
(Amplifier)
054
MPX NO AUDIO
(Exciter)
055
DECREASE PILOT PWR
(Amplifier)
055
AES/EBU NO AUDIO
(Exciter)
056
BAD INPUT RF PROTECTION
(Amplifier)
056
STEREO NO AUDIO
(Exciter)
057 STREAMING NO AUDIO
058 DIG MPX NO AUDIO
059 BATTERY LOW
060
REFERENCE VOLTAGE
061 FAN 3 ERROR
062
DRAIN VOLTAGE CONTROL
065 RTC FAULT
066 RTC USER UPDATED
067 RTC AUTOMATIC RECOVERY
068 CLIPPER ON
069 CLIPPER OFF
070 RTC SERVER NTP UPDATED
ERROR
ERROR