User Manual

9360
Series
360° Non-Contacting Rotary
Dual Output Hall Effect Sensor
170 Technology Drive West
Irvine, CA 92618-2401
[phone] Fax: [phone]
email: [e-mail]
www.beiduncan.com
The BEI Sensors 9360 Series rotary sensor is a non-contacting Hall
effect device with 360° of rotation and dual outputs. This rugged
design is ideally suited for infi nite rotation applications where reli-
ability and durability are a priority. The sensor provides absolute
position at power on and offers two completely redundant outputs.
The packaging is similar to other BEI devices and meets the severe
durability requirements that are typical in off-highway and agricul-
ture requirements. The new sensor incorporates a rotating Neodym-
ium disk magnet that enables the sensing element to remain station-
ary, improving both accuracy and reliability. This combination of
magnet, sensor and sealed packaging offers excellent temperature
stability and corrosion resistance. The sensor can be confi gured for
Analog (voltage) outputs or with a PWM output. These program-
mability features are confi gured at the factory and allow for greater
fl exibility in creating custom limited electrical angle outputs (i.e.
0-20 degrees for full scale) with short turnaround times.
Fully sealed, (meeting and/or exceeding IP66/IP67 standards) the
9360 is impervious to contamination and moisture. An integrally
molded 6-pin connector makes a sealed connection with industry
standard Packard Electric connector.
9360 Series Features
Rotating magnet / fi xed sensor confi guration
Provides improved accuracy and reliability
Fully programmable
The standard sensor provides 0-359.9° electrical degrees.
Multiple outputs with limited electrical angles up to 359.9°
temperature compensation are also available
Compression molded Neodymium magnets
Provide excellent temperature stability and corrosion resistance
Ratiometric analog output or PWM output
Factory programming through connector
Allows for quick turn-around on custom electrical angles
Sealed construction
IP66 / IP67, 6-pin I/O interface to Packard Electric Metri-Pack
Pull-to-Seat 150.2 Series P/N 12162261 or P/N 12162260 connector
Extended temperature range
-40° to +85°C standard, -40° to +125°C available optionally
Extended operating life
Maximum rotational speed limited to 300 RPM
Ordering Information
9360 XXX XX
Temperature Rating:
Blank = Standard +85°C
HT = +125°C
Requested Electrical Angle:
i.e. 090 = ±45° or 120 = ±60°
SAMPLE: 9360 090
Standard +85°C
90° (±45˚) Electrical Angle
Infinite 360° Rotation Device
ISO9001 & TS16949 Certifi ed