Manual

Page 9 Inclinometer RS232 – Switch Datasheet Version: 20130503
INCLINOMETER
RS232 – SWITCH
7 Serial Interface RS 232
Communication with the sensor is done through a
standardized RS-232 interface. Data transmission
is effected in duplex mode. The baud rate is fixed
by 9600 baud. After Power On the sensor is
sending continuous the angle values in degrees
(°). In the setup level several settings can be
permanently modified. If the continuous mode was
permanently changed to the polling mode, the
sensor will send after Power On a start information
with actual parameters. On error no angle values
are sending and after Power On an error message
was add to the start information.