Instruction Manual

Hardware Replacement
6.4 ReplacingtheCompleteFront
The following is needed:
• Anewfront,seeAvailable Spare P arts for EPC T A100 AM
• AtorxT10screwdriver
Note:
MakesuretouseadequateESDprotection.
Follow the steps below to replace the complete front of the EPC TA100 AM:
1.
Power off the Panel PC.
2.
Follow the steps 1-3 and 5 in the Replacing the Display/Display Cable instruc-
tions, but in step 3, only disconnect the flex cables and the LED cable (do not
remove the power card).
3.
Attach the new front.
4.
Re-assemble the unit.
BeijerElectronics, MAEN043
22