Manual

Hardware Replacement
8.6 ReplacingtheBacklight
Note:
Alllampsinthedisplaymustbereplacedatthesametime.
The following is needed:
• A new backlight, see Available Spare Parts for iX P anel T100
• AtorxT10screwdriver
Note:
MakesuretouseadequateESDprotection.
Follow the steps below to replace the battery of the iX Panel T100:
1.
First, follow the steps 1–5 in section Replacing the Rear Cover.
2.
Gently move the backlight diagonally in direction from the display center to
release the snap-in closure that keeps the backlight in place.
3.
Remove the backlight from the display.
backlight snap lock
backlight
connectors
4.
Insert the new backlight. Be careful not to pull the cables of the new backlight
when inserting it, since pulling the cables will damage the backlight.
5.
Re-assemble the complete operator panel.
BeijerElectronics, MAEN007
27