Instruction Manual

Additional Hardware
7 AdditionalHardware
7.1 MemoryCard
An internal Compact Flash memory card can be used in iX Panel T150 for
expansion of the project memory.
Note:
WhenusinganinternalCompactFlashmemorycard,noexternalCompactFlash
memorycardcanbeused. AnexternalUSBFlashdrivecanbeusedforthesame
functionsasanexternalCompactFlashcard.
Compact Flash cards of type I and II are supported.
Compact Flash cards of the following brands and models are recommended:
SiliconSystemsSiliconDrive
SanDiskIndustrialGrade
Cactus203-,3 02-and303–series
Other Compact Flash cards may be approved as accessories for the iX Panels even
if they are not present in the above list, due to product changes and upcoming
brands.
7.1.1 Installation
Perform the following steps to install an internal Compact Flash card in the
operator panel:
1.
Turn off the power to the panel.
Note:
MakesuretouseadequateESDprotection.
2.
Follow the instructions in the Replacing the Rear Cover section to remove the
rear cover.
3.
Flip the back cover; the CPU board is mounted inside the back cover.
4.
Insert the Compact Flash memor y card in its slot on the CPU board.
memory card slot
BeijerElectronics, MAEN008
19