Instruction Manual

Hardware Replacement
8.4 ReplacingtheDisplay/Display
Cable
The following is needed:
• A ne w display/display cable, see Available Spare Parts for iX Panel T150
• AtorxT10screwdriver
Note:
MakesuretouseadequateESDprotection.
Follow the steps below to replace the display/display cable:
1.
Power off the operator panel.
2.
Follow the instructions under Replacing the Rear Cover to remove the rear
cover.
3.
Disconnect the two flex cables the flex cable and the LED cable from the
power card and remove the two plastic nuts that h old the power card in place.
LED cable
plastic nut
display cable
plastic nut
4.
Lift the power card and gently remove the backlight cables and the display
cablefromtherearsideofthepowercard.
backlight cable
backlight cable
display cable
BeijerElectronics, MAEN008
24