Instruction Manual

Software
13 Software
This chapter describes how to maintain and update the software in the iX Panels.
The chapter includes a general description of the operator panel software and
instructions about how to upgrade the software and load projects and system
programs.
13.1 GeneralInformationabout
Software
The software require d to run and maintain the operator panels is found on the
software USB stick. It is also available through your local distributor.
The software is tested by the manufacturer’s own t esting department before
market introduction is approved. The test procedure is closely integrated with the
development process. The test group works in close concert with the developers
andisISEBCertifiedforSoftwareTesting.
13.1.1 SoftwareProducts
The following software products are used:
• iX Developer
iX Developer is used for creating application projects for iX Panels and their
accessories.
• Remote Access Viewer
Remote Access Viewer is a program for remote ac
cess and control of theiX Panels.
It is possible to access, reflect and control t
he iX Panels from a PC using the VNC
client program Remote Access Viewer (freew
are) together with th e built-in VNC
server (Remote Access function) in th
eiXPanels.
• System Program
The iX Panel T150 is delivered with a system program ( operating system)
pre-stored in the operator panel memory.
The firmware (the software in the operator panel) consists of three parts at
delivery:
1. E-Boot, the program that starts up the operator panel and Windows CE.
2. Windows CE .net 4.20, the operating system for the operator panel.
3. OPsys, the system program in the operator panel that contains the H MI
functionality.
BeijerElectronics, MAEN008
42