Technical Manual

14
7 Technical Support
If you have any questions or suggestions about the Essential Series of Century AM systems, please do not
hesitate to contact our technical support by email technicalsupport@century-cn.com
, or our salespersons
directly.
FCC
This device contains FCC ID: 2AP7X-DRM3
This device complies with part 15 of the FCC Rules. Operation is subject to the follow
ing two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired
operation.
Caution the user that changes or modifications not expressly approved by the party res
ponsible for compliance could void the user's authority to operate the equipment.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with a minimum distance of 20mm between the radiator &
your body. This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the re
ceiver is connected.
Consult the dealer or an experienced radio/TV technician for help