User's Manual

Set camera parameters. On the WEB management interface, click [Device Configuration] ->
[Settings] -> [Camera Parameters] in the navigation bar to configure camera parameters. After
configuring, click OK.
For backlighting scenario, you can set the BLC and DWDR to “Open” to get a better image.
5.2 Blackbody Bluetooth Connection Failure
First, confirm the Bluetooth antenna is connected.
Next, check if the MAC address shown in ‘Firmware’-‘Bluetooth setting’ is the same as the
MAC address on the label posted at the bottom of blackbody or not. If same, input the MAC address
again.
If the Bluetooth connection still fails, connect a monitor and mouse to the host. Then right click