User's Manual

Instructions for use

On/O

Start Cleaning

Press and hold the button to power on the robot. The power indicator

will turn on and the robot will enter standby mode. When the robot is

idle, press and hold the button to turn o the robot and complete the

cleaning cycle.

Press the button to start cleaning. The robot will plan its cleaning

route according to its scan of the room. It splits a room into zones, rst

draws out zone edges, then lls the zone in a zigzag pattern. In so doing,

the robot cleans all zones one by one, eciently cleaning the house.

Note:

The robot cannot be turned o when it is being charged.

Zone 1 has

been cleaned.

Zone 4 is

pending.

Zone 1 has

been cleaned.

Zone 3 is

being cleaned.

Note:

Cleaning cannot start if the battery level is too low. Allow the robot to charge before restarting cleanup.

Before cleaning, tidy cables (including the power cable of the Charging Dock) from the oor. Loose cables

may be dragged by the robot, resulting in the disconnection of electrical appliances or damage of cables

and property.

If cleaning is completed in less than 10 minutes, the area will be cleaned twice.

If the battery runs low during the cleaning cycle, the robot automatically returns to the Charging Dock.

After charging, the robot will resume where it left o.

・

Sleep

If the robot is paused for over 10 minutes, it will go to sleep, and the

power indicator will ash every few seconds. Press any button to wake the

robot up.

Note:

The robot will not go to sleep when it is on the Charging Dock.

The robot will automatically shut down if left in sleep mode for more than 12 hours.

・

Pause

When the robot is running, press any button to pause it.

Then press the button to continue cleaning or the button to

return it to the Charging Dock and stop the cleaning cycle.

Note:

Placing a paused robot on the Charging Dock manually will end the current cleanup.