User's Manual
Table Of Contents
- Main Features
- PINNING INFORMATION
- 3. baud rate Setting
- 4. Communication Protocol
- 4-1. Communication Setting
- 4-2. Communication Format
- 4-3. Command Overview
- 4-4. Command List
- 4-4-1. Select Mifare card
- 4-4-2. Login to a sector
- 4-4-3. Read a data block
- 4-4-4. Write a data block
- 4-4-5. Read a value block
- 4-4-6. Initialize a value block
- 4-4-7. Write master key (key A)
- 4-4-8. Increment value
- 4-4-9. Decrement value
- 4-4-10. Copy value
- 4-4-11. Read a data page (Ultralight & NTAG203)
- 4-4-12. Write a data Page (Ultralight & NTAG203)
- 4-4-13. Download Key
- 4-4-15. Request for Answer to Select (ISO14443-4)
- 4-4-16. Exchange Transparent Data (T = CL)
- 4-4-17. LED Control
- 4-4-18. Power Down
- 4-4-19. 3Des Authentication(Utralight C)
- 4-4-20. Update Key(Utralight C)
- 4-4-21. Write Perso
- 4-4-22. Commit Perso
- 4-4-23. Get firmware version
- 4-4-24. Turn on/off Auto-detection
- 5. DIFFERENCES FROM PREVIOUS VERSION
Federal Communications Commission (FCC) Interference Statement
The limited modular transmitter is only FCC authorized for the specific rule part (FCC Part15.225)
listed on the grant, and that the host product manufacturer is responsible for compliance to any other
FCC rules that apply to the host not covered by the modular transmitter grant of certification.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
For additional hosts other than the specific host originally granted with a limited module, a Class II
permissive change is required on the module grant to register the additional host as a specific host
also approved with the module.
OEM/Host integrator is responsible for complying with the instructions and requirements for each
transmitter they choose to integrate into a host product.
RF exposure warning
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment.
This product may not be collocated or operated in conjunction with any other antenna or transmitter.
This equipment must be installed and operated in accordance with provided instructions and the
antenna(s) used for this transmitter must be installed to provide a separation distance from all persons
and must not be collocated or operating in conjunction with any other antenna or transmitter.
Additional text needed for the host product manufacturer to provide to end users in their end-product
manuals.