User's Manual
Table Of Contents
- Main Features
- PINNING INFORMATION
- Device Operation
- Command Description
- 4-2. Command Overview
- 4-3. Command List
- 4-3-1. Select Mifare card
- 4-3-2. Login to a sector
- 4-3-3. Download Key into SL030
- 4-3-4. Login sector via stored key
- 4-3-5. Read a data block
- 4-3-6. Write a data block
- 4-3-7. Read a value block
- 4-3-8. Initialize a value block
- 4-3-9. Write master key (KeyA)
- 4-3-10. Increment value
- 4-3-11. Decrement value
- 4-3-12. Copy value
- 4-3-13. Read a data page (UltraLight & NTAG203)
- 4-3-14. Write a data Page (UltraLight & NTAG203)
- 4-3-15. Request for Answer to Select (ISO14443-4)
- 4-3-16. Exchange Transparent Data (T = CL)
- 4-3-17. LED Control
- 4-3-18. Power Down
- 4-3-19. Write Perso
- 4-3-20. Commit Perso
- 4-3-21. Get firmware version
- 4-3-22. Turn on/off Auto-detection
- 4-3. Command List
- Differences from previous version
StrongLink SL030 3.1
http://www.stronglink-rfid.com
3
1. MAIN FEATURES
*This picture may not be exactly the same as real object.
• Tags supported: Mifare 1k, Mifare 4k, Mifare UltraLight, Mifare
UltraLight C, NTAG203, DESFire, DESFire EV1 and Mifare Plus
2K/4K
• Built-in antenna
• 0 to 400 KHz bit-wide I
2
C-bus communication
• 2.7 ~ 3.6V VDC operating, I/O pins are 5V tolerant
• Work current less than 45mA @3.3V
• Power down current less than 10uA
• Operating distance: Up to 50mm, depending on tag
• Storage temperature: -40 ºC ~ +85 ºC
• Operating temperature: -25 ºC ~ +55 ºC
• Dimension: 38 × 38 × 3 mm
• The OUT pin at low level indicates tag in detective range, and high
level indicating tag out
• Auto-detection: LED is on when card is in the detection range
1
• Support IAP firmware update
1
Suppots all cards above except ISO14443-4 cards like DESFire/DESFire EV1 and MifarePlus L0/L2/L3. There is
Auto-detection command to control its on/off.