User's Manual
Table Of Contents
- Main Features
- PINNING INFORMATION
- Device Operation
- Command Description
- 4-2. Command Overview
- 4-3. Command List
- 4-3-1. Select Mifare card
- 4-3-2. Login to a sector
- 4-3-3. Download Key into SL030
- 4-3-4. Login sector via stored key
- 4-3-5. Read a data block
- 4-3-6. Write a data block
- 4-3-7. Read a value block
- 4-3-8. Initialize a value block
- 4-3-9. Write master key (KeyA)
- 4-3-10. Increment value
- 4-3-11. Decrement value
- 4-3-12. Copy value
- 4-3-13. Read a data page (UltraLight & NTAG203)
- 4-3-14. Write a data Page (UltraLight & NTAG203)
- 4-3-15. Request for Answer to Select (ISO14443-4)
- 4-3-16. Exchange Transparent Data (T = CL)
- 4-3-17. LED Control
- 4-3-18. Power Down
- 4-3-19. Write Perso
- 4-3-20. Commit Perso
- 4-3-21. Get firmware version
- 4-3-22. Turn on/off Auto-detection
- 4-3. Command List
- Differences from previous version
StrongLink SL030 3.1
http://www.stronglink-rfid.com
6
3-5. Busy State
When the SL030 has received command, then don’t acknowledge IIC bus until ends with
the card communication.
3-6. Device Addressing
The SL030 devices require an 8-bit device address word following a start condition to
enable the chip for a read or write operation.
The device address word consists of 7 bits addressing and 1 bit operation select bit.
The first 7 bits are the SL030 addressing, is 10100xx depend on JP1 and JP2 status as
below table
JP1
JP2
Address
shorted
no no
1010000
( default )
no
yes
1010001
yes
no
1010010
yes
yes
1010011
The eighth bit of the device address is the read/write operation select bit. A read operation
is initiated if this bit is high and a write operation is initiated if this bit is low.