User's Manual

3.Operation
UP Plus 2 User Manual 13
6. Put the ABS plastic spool onto the holder (choose one type of holder you like), and
thread the ABS filament into the feeder and press the micro switch. The filament will
automatically feed material for as long as you hold down the switch. Please remember
to insert the end of the ABS filament into the filament tube.
7. Insert the end of ABS filament into the Filament tube. Press the feed switch until
the filament goes all the way through the filament tube, and about 10cm of filament
protrudes from the tube.
Start the UP! Software (refer to the software install procedure in 3.1.2 if you have not
already installed it), and press the ―Extrude‖ button in the ―maintenance‖ dialogue
box, which is accessed from the ―3D Print‖ menu. After the printer nozzle has
warmed up to 260°C, the printer will beep. Push the filament into the hole at the top