Users Manual Part 1

5.3 Load Filament

You will find two spools of filaments in the package.

1. 500g Tiertime PLA

2. 500g Tiertime PVA

In order to archive good consistency and print quality, we recommend use Tiertime

filaments. The default print settings of UP Studio are optimized using Tiertime

materials, so you can start printing confidently without adjusting any parameters.

Load Main Material (1)

To install the filament, please following the instruction below:

1. Remove the vacuumed bag.

2. Find the end of the filament, and use pliers to make a clean cut of the end.

3. Open the door of the filament bay, feed it into the guiding tube, you should able to

feel the filament triggered mechanical switch (filament sensor) at the opening.

4. Keep feeding the filament until the end of the filament sticks out from the other

end of the guiding tube (You can open the top lid, and make sure the filament sticks

out).

Insert filament into guiding tube, must go

through the filament sensor.