Users Manual Part 1

7.5 Vertical Calibration

Vertical Calibration. The main purpose of Vertical Calibration is to ensure all three

axes are perpendicular to each other in order to guarantee consistent, high-quality

prints.

1. Find the VC.stl in the installation directory of UP Studio. Load it in UP Studio

software, and follow the normal process to print it.

2. After the model printing is done, take out the build surface with the printed model

on it. Don’t remove the object from the surface. The printed model includes 4 corners,

and 4 L-shapes.

3. In the UP Studio Software, find Model Calibration. Click Default before entering

any new values into the edit fields.

4. Perform X/Y measurements. Use a thin ruler or a Vernier scale to measure the

diagonal length of the printed model from one corner to the opposite corner, as

shown in the figure below for X1. Then, do the same for X2. Enter the values for X1

and X2 into the software.

5. Click the Confirm button to complete the X/Y axis calibration. The software will

round those values to the nearest tenth.