Users Manual Part 1

37
3. Point
support
Support the “Tip”
features
Support Angle
The overhang angle threshold for support, overhangs less than
this angle will not have support generated.
Top Layer
This determine number of interface layers between the support
structure and the surface being supported. Increase the layer may
make the support easier to remove but increase print time.
Top Lift
Determine how many layers the support will lift above the layer of
the point feature. This setting cannot be 0 as the “point” cannot
be supported if the supporting structure is within the same layer
as the tip.
Support
Parameters
Support List
View Options
Support Preview