Users Manual Part 1

41
Introduction to print parameters:
Entities of a Part: The model when sliced is divided into different regions or Entities,
and each these entities’ print setting can be adjusted individually.
Perimeter: The wall/shell of the model. The outter most layer is the “Outter
Perimeter”, all the perimeter inside the Outter perimeter are “Inner Perimeters”
Infill
: the region inside the perimeter, can be filled with certain patterns and density
Top/Bottom
: The roof and bottom layers of the print
Support:
Automatically generated structure that support the overhang structures
Raft:
Thick layers that are under the print to improve adhesion and also
compensate for unevenness of platform surface.
For most up-to-date details of print settings, please go to Tiertime knowledge base:
https://support.tiertime.com/xxxxxxxxx
Bottom
Layers
Outter Perimeter
(Blue)
Top
Layers
Infill
Support
Top Layers
Raft
Outter Perimeter
(Blue)
Support
Support Top
Layers
Infill
Inner Perimeter
(Green)
Inner
Perimeter
(Green)
Support