Users Manual Part 1

42
1.Slice
Term
Unit
Description
Quality
Layer Thickness
mm
Layer thickness of print, the bigger the thickness the faster the print
speed and lower the print quality.
Max. Layer
Thickness
mm
Adaptive layers is to automatically adjust layer thickness base on the
overhang angle. Set the largest layer thickness for adaptive layers.
Adaptive ratio
N/A
The bigger the adaptive ratio, the more discrete shift from thin to
thick layers through overhangs. Overall the algorithm will more
inclined to use thicker layers when the ratio increases.
Layer thick = Max (normal thick, min( thick, normal
thick*tan(angle) ))*ratio
Custom
N/A
Custom layer thickness. Allow user to define specific layer thickness
for define height range:
Syntax: [start height, end height]layer thickness
Eg. [0,10]1.0[25,35]1.0
 For regions that are not defined by custom layer thickness,
default layer thickness setting will be used.
 Custom layer thickness will override the adaptive layer function.
Path Width
Outer Profile
mm
Line width of the outter most Perimeter
Inner Profile
mm
Line width of the inner perimeter
Top
mm
Line width of top layers
Bottom
mm
Line width of bottom layers
Infill
mm
Line width of inner infills
Support
mm
Line width of supports
Height: 25-35mm
Layer: 1.0 mm
Height: 0-10mm
Layer: 1.0 mm