Users Manual Part 1

44
will be generated
Layer
Layer
Number of interface layer (Support Top Layer) between object and
support column. Support top layer also added between raft and part
bottom surface, so this option will also increase apparent thickness
of raft stucture.
Min. Area
mm
Area Threshold of overhang surface, overhang area smaller than this
will not be supported.
Min. Length
mm
Length Threshold of overhang edge. Overhang edge shorter than this
will not be supported.
Stretch Angle
o
The angle to expand the base of support column. Refer to xxx page.
Suspend Lift
Top Lift
mm
Only applied to point or edge features.Top lift represent the height
which the support will “wrap” above the actual supporting point or
edge. If the part contain pointy features that is facing down, it is
recommend to increase top lift options.
Raft
Layer
Layer
How many layer the raft will consist
Thick
mm
Layer thickness of raft
Base Width
mm
Path width of the first 2 layers of raft
Expand
mm
How much to expand from the perimeter of the bottom layer for the
raft layer
Mode
N/A
Raft infill mode, Profile is for Tiertime printer only, the raft is generated
by printer. The pattern is not visible at this stage.
The hatch and offset are for non-Tiertime printer, Tiertime machines
cannot use these 2 types.