Users Manual Part 1

2. Unboxing

2.1 Unboxing the UP300D

1. Cut open the tape on the top of the cardboard box, and open the box from the top.

2. Take out the two boards on the top foam, and remove the top foam.

3. Remove the plastic cover and the square shaped foam wrapping around the

machine.

4. Lift the printer out of the cardboard box using two handles on both sides of the

printer, and place it on a flat surface.

5. Open the Top Lid and remove all the tights and foams inside the printer. There are

six tights in the machine.

6. Open the Front Door, and take out the two foams and two extruders beneath the

build platform. As figures show below:

7. Take out the roll of filament, the accessory box and the power cord at the bottom

of the cardboard box.

8. Put all the foams back to the box, and keep the box for the future use.