User's Manual

25
Main material
(Filament 1)
Support material
(Filament 2)
Main material
(Filament 1)
Support material
(Filament 2)
6.2 Load Main and Support Material
When switched to dual
extruder,the printer will able to
recognize the print head and
adjust the interface accordingly.
The material interface will have
two material options. Filament 1
is the main material and filament
2 by default is the support
material.
For dual extrusion version of UP600, you will find two spools of filaments in the
package.
1. 500g Tiertime PLA
2. 500g TiertimePVA
In order to archive good consistency and print quality, we recommend use Tiertime
filaments. The default print settings of UP Studio are optimized using Tiertime
materials, so you can start printing confidently without adjusting any parameters.
Load Main Material (1)
To install the filament, please following the instruction below:
1. Remove the vacuumed bag.
2. Find the end of the filament, and use pliers to make a clean cut of the end.
3. Open the door of the filament bay, feed it into the guiding tube, you should able to
feel the filament triggered mechanical switch (filament sensor) at the opening.