User's Manual

41
Draft Angle = 0
Draft Angle = 50
Min. Area
Area threshold of the support structure, overhang surface with area less
then the threshold will not be supported.
Min. Length
Length threshold for the edge support. Edges shorter than the threshold
will not be supported.
Support List
Enable：turn support on or off.
View: hide/show support, not affecting its status.
Remove: remove support from list, not affecting its status.
Support Filter
Filter allow user to setup conditions to only show a subset of supports in the support list.
This conditions could be:
1. Support Type
2. Support Status
3. Supported Surface Area
4. Location on the XYZ plane.
The support filter is a quick way to find and selectively edit specific supports.