User's Manual

44
Inner Perimeter
(Green)
8.6 Introduction to print parameters
Entities of a Part: The model when sliced is divided into different regions or Entities, and
each these entities’ print setting can be adjusted individually.
Perimeter: The wall/shell of the model. The outter most layer is the “Outter Perimeter”, all
the perimeter inside the Outter perimeter are “Inner Perimeters”
Infill: the region inside the perimeter, can be filled with certain patterns and density
Top/Bottom: The roof and bottom layers of the print
Support: Automatically generated structure that support the overhang structures
Raft: Thick layers that are under the print to improve adhesion and also compensate for
unevenness of platform surface.
Entity IDs: different entity can be represented with a ID number, these IDs then could be
assigned to an extruder, so that the entity will be printed by a specific extruder. Please refer
to extruder setting for more info on this topic.
For most up-to-date details of print settings, please go to Tiertime knowledge base:
https://support.tiertime.com/xxxxxxxxx
Outter Perimeter
(Blue)
Raft
Support
Support Top
Layers
Infill