User's Manual

72
Chapter 13. Print Boards
There are two build plates in the UP600 package.
13.1 Perf Glass Boards
The one with many small holes on one side of the board. Perforated surface has the
strongest surface adhesion when used with raft setting. It is made for printing
material with high shrinkage ratio that tend to warp during printing and frequently
used in conjunction with the HT extruder. Use this print board for: ABS, PC, Nylon,
PP and etc.
13.2 Flex Glass Board
The Flex board is made by adding a layer of plastic sheet onto the Perforated
surface. (Although extra layer of material is added the total thickness of Flex Galss is
same as Perf Glass). It is made for materials that has low shrinkage ratio, so that
they do not warp as much as material mention above.
Use this print board for: PLA, PETG, PET, TPU and etc.
13.3 Glass Surface
Both build plate have glass side that can be used for printing. It is similar to Flex
board in terms of suitable material. User can use the Glass side and print with raft
turned off to obtain a flat smooth surface. However the machine need to leveled
mechanically and the nozzle the height value may need to be adjusted (offset) for
optimal result.
Perforate Surface
“Flex” Surface
Glass
Suitable Material：
ABS, PC, Nylon, PP and etc.
Suitable Materials：
PLA, PETG, PET, TPU and etc.
*Flex/ Perf Glass Board: Glass boards could break if dropped. Please handle with care.