Operating instructions

Fault elimination
BEKOSPLIT® 11 35
The plant is in the STOP mode
(e.g. after power outage or actuation of
the STOP button)
• Press the START button to switch the
plant to "AUTOMATIC"
No LED is lit, although operating volt-
age is applied to the power unit
• Check the connection cable between
the power unit and the plant control
at the front
• Check the plug-in connector of the
connecting cable at the plant control
• Check/replace the fuse of the power
unit as follows:
1. Unscrew the screws of the hous-
ing cover
2. Remove the housing cover and
place it on the BEKOSPLIT
®
11
3. Replace the fuse with a fuse of
the same type and nominal ca-
pacity (see technical data)
Pos: 139 /---- Seit enumbruch ---- @ 0\mod_1 15702809901 5_0.docx @ 2903 @ 1@ 1