Instruction manual

EN
5
Electrical Requirements
Before you insert the plug into the
wall socket make sure that the voltage
and the frequency shown on the rating
plate inside the appliance corresponds
to yourelectricity supply.
Rating label is on the left hand side of
fridge inner liner.
We recommend that this appliance be
connected to the mains supply via a
suitable switched and fused socket.
The appliance must be positioned so
that the plug is accessible.
Should the mains lead of the appliance
become damaged or should it need re-
placing at any time, it must be replaced
by a special purpose made mains lead
which can only be obtained from a
BEKO Authorised Service Agent.
Warning! This Appliance
Must Be Earthed
If the fitted moulded plug is not suitable
for your socket, then the plug should be
cut off and an appropriate plug fitted.
Destroy the old plug which is cut off as
a plug with bared cord could cause a
shock hazard if inserted into a socket
elsewhere in the house.
The moulded plug on this appliance in-
corporates a 13 A fuse. Should the fuse
need to be replaced an ASTABEAB ap-
proved BS 1362 fuse of the same rat-
ing must be used. Do not forget to refit
the fuse cover. In the event of losing the
fuse cover the plug must not be used
until a replacement fuse cover has been
fitted.
Colour of the replacement fuse cover
must be the same colour as that visible
on the pin face of the plug. Fuse covers
are available from any good electrical
store.
Important! Fitting A Different Plug
As the colours of the wires in the
mains lead of this appliance may not
correspond with the coloured markings
identifying the terminals in your plug
proceed as follows: (See diagram).
Connect the green-yellow or green.1
(Earth) wire to the terminal in the plug
marked ‘E’ or with the symbol
or co-
loured green and yellow or green.
Connect the blue (Neutral) wire to.2
the terminal in the plug marked ‘N’ or
coloured black.
Connect the brown (Live) wire to.3
the terminal in the plug marked ‘L’ or
coloured red.
With alternative plugs a 13 A fuse must
be fitted either in the plug or adaptor or
in the main fuse box. If in doubt contact
a qualified electrician.
FITTED WITH
BS 1362 13A FUSE ALWAYS
FIT BS 1362 REPLACEMENT
CARTRIDGE FUSE
GREEN &
YELLOW
OR
GREEN
N
BLUE
OR
BLACK
L
BROWN
OR
RED
22mm.
6mm.
6mm.
6mm.
32mm.
12mm.
FUSE
CORD GRIP