D D D D en 9430 9432 9433 9470 NM NM NM NM Instructions for use
en - Index 01-08 Safety first ....................................................../1 Electrical requirements ................................../2 Transportation instructions............................./2 Installation instructions.................................../2 Getting to know your appliance....................../3 Suggested arrangement of food in the appliance................................................../3 Temperature control and adjustment ............./4 Before operating ..................
1 12 2 3 12 13 4 14 5 16 6 5 14 5 15 7 8 9 14 10 11 14 Fig.
Fig.2 Fig.3 Fig.4 Fig.6 Fig.5 Fig.
Fig.8 Fig.9 Fig.10 Fig.11 Fig.
GB Instruction Manual Congratulations on your choice of a Quality Appliance, designed to give you many years of service. Safety first! Do not connect your appliance to the electricity supply until all packing and transit protectors have been removed. • Leave to stand for at least 4 hours before switching on, to allow compressor oil to settle, if transported horizontally.
GB Instruction Manual Electrical requirements Installation instructions Before inserting the plug into the wall socket make sure that the voltage and the frequency shown in the rating plate inside the appliance corresponds to your electricity supply. • Take care to ensure that the plug remains readily accessible. Do not use multiple adapter bar or extension cable. 1.
GB Instruction Manual portionsaccording to the daily or meal needs. •Even if food will be stored for a short period,foodshould be wrapped so that will not leak air to prevent driying. Packing materials should be resistant to cold, being torn, moisture,odor,oil and acid. And also should not let air-pass through. Besides they should be closed well, handy and made of convenient material for using in the deep freezers. 4. Dairy products should be stored in the special compartment provided in the door liner. 5.
GB Instruction Manual Temperature control and adjustment Before operating Final Check Before you start using the appliance check that: 1. The feet have been adjusted for perfect levelling. 2. The interior is dry and air can circulate freely at the rear. 3. The interior is clean as recommended under "Cleaning and care.” 4. The plug has been inserted into the wall socket and the electricity is switched on. When the door is open the interior light will come on.
GB Instruction Manual Storing frozen food How to use the accessories Your freezer is suitable for the long-term storage of commercially frozen foods and also can be used to freeze and store fresh food. If there is a power failure, do not open the door. Frozen food should not be affected if the failure lasts for less than 7 hrs.
GB Instruction Manual 6. If the appliance is not going to be used for a long period of time, switch it off, remove all food, clean it and leave the door ajar.7. We recommend that you polish the metal parts of the product (i.e. door exterior, cabinet sides) with a silicone wax (car polish) to protect the high quality paint finish. 7. Check door seals regularly to ensure they are clean and free from food particles. 8. Never: • Clean the appliance with unsuitable material; eg petroleum based products.
GB Instruction Manual Do’s and don’ts Don't- Store bananas in your fridge compartment. Don't- Cover the shelves with any protective materials which may obstruct air circulation. Don't- Store poisonous or any dangerous substances in your appliance. It has been designed for the storage of edible foodstuffs only. Don't- Consume food which has been refrigerated for an excessive length of time. Don't- Store cooked and fresh food together in the same container. They should be packaged and stored separately.
GB Instruction Manual Trouble - shooting If the appliance does not operate when switched on, check; • That the plug is inserted properly in the socket and that the power supply is on. (To check the power supply to the socket, plug in another appliance) • Whether the fuse has blown/circuit breaker has tripped/main distribution switch has been turned off. • That the temperature control has been set correctly. • That the new plug is wired correctly, if you have changed the fitted, moulded plug.