Installation Manual

11
USA
WARNING
Installation should be performed by a qualified installer. Work by unqualified
persons could be dangerous and may void the warranty.
If the dishwasher is installed in a location that experiences freezing
temperatures (e.g. in a vacation home, cabin etc.), you must drain all the
water from the dishwasher’s interior. Water system ruptures that occur as a
result of freezing are not covered by warranty.
6.6 DRAIN PREPARATION
The dshwasher dran hose may be connected to the dran plumbng n one of three ways
(Fgure A , B , C ).
NOTICE :
• Either one of the above methods must be used or the
dishwasher will not operate properly.
• A hose that attaches to a sink spray can burst if it is installed
on the same water line as the dishwasher. If your sink has
one, it is recommended that the hose be disconnected and
the hole plugged.
• The total length of the drain hose is 763/4” (1950mm). If a
hose extension is required, a drainage hose of equal quality
must be used.
• The maximum length must not exceed 157 ½” (4000mm).
Otherwise, the cleaning process is negatively influenced.
6.6.1 UNDER THE SINK DRAIN
Install a Y-branch tal ppe. (Fgure A )
NOTICE :
You must add a loop at least 28” (710mm) above the floor of
the cabnet and above the dran connecton n the dran hose to
prevent waste water from not dranng properly, and causng
ether poor washng results or a bad odor.
6.6.2 INSTALLING AN AIR GAP
If the local ordnance requres an ar gap (Fgure B ).
NOTICE :
Check wth local ordnance for type of ar gap requred.
6.6.3 DISPOSAL
Remove the dran connecton plug before attachng the dran
hose from the dshwasher.
Every dsposal has a hook up for a dshwasher; consult your
dsposer manual for correct connecton. (Fgure C )


