Installation Manual
10
USA
6.6 DRAIN PREPARATION
The dshwasher dran hose may be connected to the dran plumbng n one of three ways (Fgure
A
,
B
,
C
).
NOTICE :
• Either one of the above methods must be used or the dishwasher will not operate properly.
• A hose that attaches to a sink spray can burst if it is installed on the same water line as the
dishwasher. If your sink has one, it is recommended that the hose be disconnected and the hole
plugged.
• The total length of the drain hose is 763/4” (1950mm). If a hose extension is required, a
drainage hose of equal quality must be used.
• The maximum length must not exceed 157 ½” (4000mm). Otherwise, the cleaning process is
negatively influenced.
6.6.1 UNDER THE SINK DRAIN
Install a Y-branch tal ppe. (Fgure
A
)
NOTICE :
You must add a loop at least 28” (710mm)
above the floor of the cabnet and above
the dran connecton n the dran hose to
prevent waste water from not dranng
properly, and causng ether poor washng
results or a bad odor.
6.6.2 INSTALLING AN AIR GAP
If the local ordnance requres an ar gap
(Fgure
B
).
NOTICE :
Check wth local ordnance for type of ar
gap requred.
6.6.3 DISPOSAL
Remove the dran connecton plug
before attachng the dran hose from the
dshwasher.
Every dsposal has a hook up for a
dshwasher; consult your dsposer manual
for correct connecton. (Fgure
C
)