Operation Manual

Dishwasher / User’s Manual
17 / 33
EN
Preparation


2. Fll the reservor untl “MAX” level.
3. Close the ld of the reservor by
pressng on t lghtly.
C
Wpe clean any splled rnse ad
outsde the reservor. Rnse
ad that splled accdentally
wll cause foamng and t wll
eventually decrease washng
performance.


4. Turn the rnse ad amount adjuster
manually to a poston between 1 and
6 (4). If there are stans on tableware
tems after washng, level must be
C
Observe the nstructons of the
detergent manufacturer on
the package when usng tablet
detergents.
When you switch to powder
detergent from tablet detergent:
1. Make sure that salt and rnse ad
reservors are full.
2. Set the water hardness to the hghest
level and perform an empty run.
3. After the empty washng cycle, revew
the user manual and readjust the
water hardness level so as to sut the
water supply.
4. Make the approprate rnse ad
settngs.
C
Dependng on the model,
salt ndcator and/or rnse ad
ndcator must be enabled agan
f they were dsabled before.
Rnse ad
C
The rnse ad used n
dshwashers s a specal
combnaton used to ncrease
dryng effcency and prevent
water or lmescale stans on the
washed tems. For ths reason,
care must be pad to have rnse
ad n the rnse ad reservor
and to use rnse ads produced
specally for dshwashers only.
1. Open the ld of the rnse ad reservor
by pressng ts latch (B).