Dryer DPU 7360 GX
Please read this user manual first! Dear Customer, We hope that you get the best results from the product which has been manufactured in state-of-the-art plants and passed through a strict quality control procedure. Therefore, please read the entire user manual carefully before using the product and keep it as a reference for future use. In case of transferring the product to someone else, give the manual as well. The user manual will help you use your product in a fast and safe way.
1 Important safety instructions This section contains safety instructions that will help protect from risk of personal injury or property damage. Failure to follow these instructions shall void any warranty. General safety • • • • • • Never place the product on a carpetcovered floor; otherwise, lack of airflow beneath the machine will cause electrical parts to overheat. This will cause problems with your product. Do not operate the product if the power cable / plug is damaged.
• • • • • • • warm, causing an oxidation reaction in the oil. Oxidation creates heat. If the heat cannot escape, the items can become hot enough to catch fire. Piling, stacking or storing oil-affected items can prevent heat from escaping and so create a fire hazard.
• • • • • • • • • • • instructions of their manufacturers. Do not install the product behind a door with a lock, sliding door or a hinged door which can strike the product. Do not install or leave the dryer in places where it will be exposed to outdoor conditions. Your product can be operated at temperatures between +5°C and +35°C. If the operating conditions fall outside of this range, operation of the product will be adversely affected and it can get damaged. Do not tamper with the controls.
2 Installation Refer to the nearest Authorized Service Agent for installation of the product. To make the product ready for use, make sure that the electricity and water drainage system are appropriate before calling the Authorized Service Agent. If they are not, call a qualified technician and plumber to have any necessary arrangements carried out. Preparation of the product's location as well as the electrical and waste water installations is under customer's responsibility.
A While using undercounter dryer, it should never be operated without undercounter installation part. Dryer Depth 60 cm 54 cm Stock number of under-bench 2979600100 2973600100 installation part • Connecting to the drain In products equipped with condenser unit, water accumulates in the water tank during the drying cycle. You should drain accumulated water after each drying cycle.
C to a height of maximum 80 cm. Make sure that the water drain hose is not stepped on and it is not folded between the drain and the machine. B Adjusting the feet B In order to ensure that the product operates more silently and vibration-free, it must stand level and balanced on its feet. Balance the machine by adjusting the feet. Turn the feet to left or right until the machine stands level and firmly. have a contact distance of minimum 3 mm.
Disposing of the old product Dispose of the old product in an environmentally friendly manner. Refer to your local dealer or solid waste collection centre in your area to learn how to dispose of your product. For children's safety, cut the power cable and break the locking mechanism of the loading door so that it will be nonfunctional before disposing of the product. C Water collected during operation is pumped to water tank. It is normal to hear pumping noise during this process.
3 Preparations for drying Things to be done for energy saving machine is not in use. Following information will help you use the product in an ecological and energyefficient manner. • Operate the product at a capacity suitable for the program you have selected and pay attention not to overload. • Spin your laundry at the highest speed possible when washing them. Thus, the drying time is shortened and energy consumption is reduced. • Dry the same type of laundry together.
Items cleaned, washed or spotted with gasoil/fuel oil, dry-laundry solvents, industrial chemicals or other combustible or explosive materials should not be dried in the dryer. Items soiled with cooking oils, acetone, alcohol, fuel oil, kerosene, stain removers, turpentine, paraffin and paraffin removers must be washed in hot water with plenty of detergent before being dried in the dryer.
Loading the laundry 1. Open the loading door. 2. Place the laundry in the machine without compressing. 3. Push the loading door to close. Ensure that no items are caught in the door.
4 Selecting a Programme and Operating Your Machine Control panel 1 2 3 4 5 Daily Jeans Shirts Iron Dry Xpress Wool Refresh Spin / Time Cupboard Dry Mix Start/Pause Iron Dry Cupboard Dry Sport Babycare Time Delay Extra Dry Freshen Up Delicates Cancel Press & Hold 3 sec. Synthetics Cottons On / Off Timer Programmes Buzzer Cancel 9 8 Dryness Level 7 AntiCreasing 6 1. Washing Machine Spin Speed / Timer Programme Selection button 2. Display 3. Start / Pause / Cancel button 4.
Cottons Synthetics Express Filter cleaning Babycare Jeans Sport Shirt Spin Iron Dry Extra dry Cupboard Anti Timer Ventilation Dry Creasing programs Buzzer/ cancel On/Off Start pause cancel Tank full Mixed Timer Delay Wool Refresh Drying Rack Preparing the machine Daily Dryness Delicates Level C For further programme details, 1. Plug in the machine. 2. Place the laundry in the machine. 3. Press the On / Off button.
machine. • Shirt This programme dries the shirts more sensitively and creases them less and thus, helps to iron them more easily. There may be a little moisture on the shirts at the end of the programme. We recommend you not to leave the shirts in the dryer. • Jeans Use this programme to dry your jeans that are spun at high speeds in the washing machine. • Mixed Use this programme to dry nonpigmenting synthetic and cotton laundry items together.
Programme selection and consumption table EN Programs Capacity (kg) Spin speed in washing machine (rpm) Approximate amount of remaining humidity Drying time (minutes) Cottons / Coloreds A Extra dry 7 1000 % 60 175 A Cupboard dry 7 1000 % 60 156 A Iron dry 7 1000 % 60 125 Babycare 3 1000 % 60 80 Shirt 1.
Auxiliary functions Audio Warning The machine will give an audio warning when the programme comes to an end. If you do not want the machine give an audio warning, press the Volume Level button repeatedly until "x" appears on the display. Use the same button to adjust the volume level. You can activate this function either before or after the programme starts.
pause. Drain the water in the water tank and press Start / Pause / Cancel button to resume the programme. The warning symbol turns off and the programme resumes operating. countdown process, Time Delay symbol disappears, drying process starts and the programme duration is displayed. The time on the display is the total of normal drying time and delay time. Cleaning of filter drawer Warning symbol flashes with certain intervals to remind that the filter drawer needs to be cleaned.
Starting the programme Child-proof Lock Press Start / Pause / Cancel button to start the programme. Start / Pause symbol will light up to indicate that the programme has started and ":" symbol between the remaining time will continue flashing. Progress of programme Drying Iron Wardrobe (Extra) Anticreasing Ventilation Progress of a running programme is indicated on the display by means of a set of symbols.
1. If you want to select Extra Dry programme instead of Iron Dry programme, press and hold the Start / Pause / Cancel button for 3 seconds to cancel the programme. 2. Select Extra Dry programme by turning the Programme Selection knob. 3. Press Start / Pause / Cancel button to start the programme. You can also select a new programme by turning the Programme Selection knob while the machine is operating. In this case, current programme is aborted and the new programme information appears on the display.
the display. End of programme Lint Filter Cleaning and Water Tank warning symbols light up in the programme follow-up indicator and "End” label appears on the display when the programme comes to an end. The loading door can be opened and the machine becomes ready for a second cycle. Press On / Off button to switch off the machine. C If Anti-creasing function is activated C C and the laundry is not taken from the machine at the end of the programme, 2-hours Anti-creasing programme is activated.
5 Maintenance and cleaning Service life of the product extends and frequently faced problems decrease if cleaned at regular intervals. This product must be unplugged during maintenance and cleaning works (control panel, body, etc.). up on the lint filter surface. Dry the lint filter completely before reinstalling it. B Lint Filter / Loading Door Inner Surface Lint and fibres released from the laundry to the air during the drying cycle are collected in the Lint Filter.
There are dampness sensors in the machine that detect whether the laundry is dry or not. To clean the sensors: 1. Open the loading door of the machine. 2. Allow the machine to cool down if it is still hot due to the drying process. 3. Wipe the metal surfaces of the sensor with a soft cloth, dampened with vinegar and dry them. Clean metal surfaces of the sensors 4 times a year. Do not use metal tools when cleaning metal surfaces of the sensors.
2. Remove the filter drawer cover by turning it in the direction of arrow. 6. Clean lint, fibre, and cotton raveling on the filter cloth by hand or with a soft piece of cloth. 3. Pull out the filter drawer. C When you notice a layer that may 4. Open the filter drawer by pressing the red button. lead clogging on filter cloth, please clean the layer by washing in warm water. Let the filter cloth dry thoroughly before installing back the filter drawer. 7.
Cleaning the evaporator 10. Place the filter drawer back into its place, turn the filter drawer cower clockwise making sure that it is closed securely. Clean the lints accumulated on the fins of the evaporator located behind the filter drawer with a vacuum cleaner. 11. Close the kick plate cover. C You can also clean by hand provided that you wear protective gloves. Do not attempt to clean with bare hands.
6 Troubleshooting Drying process takes too much time. • Pores of the lint filter are clogged. >>> Wash the lint filter with warm water. • Filter drawer is clogged. >>> Clean the sponge and the filter cloth in the filter drawer. • Ventilation grids on the front side of the machine are blocked. >>> Remove the objects (if any) that block ventilation in front of the ventilation grids. • Ventilation is not sufficient since the room where the machine is installed is very small.
Drum lighting does not turn on. (On models with lamp) • Dryer is not switched on with the On / Off button. >>> Make sure that the dryer is switched on. • Lamp is defective. >>> Call Authorized Service Agent to have the lamp replaced. End/Anti-creasing symbol is on. • Anti-creasing programme is activated in order to prevent laundry that has remained in the machine from creasing. >>> Turn off the dryer and take out the laundry. End symbol is on. • Programme is over.