Printed in Turkey Part no: 48 2570 00 00 Revision no: 0 R E F R I G E R A T I O N BEKO plc Beko House Caxton Way Watford Hertfordshire WD18 8UF Tel: 01923 654650 Fax: 01923 819653 e-mail: service@beko.co.uk website: www.beko.co.uk TLDA 625 11 cu.ft.
Congratulations on your choice of a service for many years. quality Appliance which has been designed to give you WARNING ! IMPORTANT ! DO NOT connect your appliance to the electricity supply until all packing and transit protectors have been removed. • Leave to stand for at least 4 hours before switching on to allow compressor oil to settle if transported horizontally.
ELECTRICAL REQUIREMENTS Before you insert the plug into the wall socket make sure that the voltage and the frequency shown in the rating plate inside the appliance corresponds to your electricity supply. Rating plate is affixed on the left hand side of inner liner We recommend that this appliance is connected to the mains supply via a suitable switched and fused socket. The appliance must be positioned so that the plug is accessible.
IMPORTANT INSTALLATION INSTRUCTIONS 1. The space in the room where the appliance is installed must not be smaller than 10 cubic metres. 2. If possible avoid placing the appliance near cookers, radiators or in direct sunlight as this will cause the compressor to run for long periods.
The following guidelines and recommendations are suggested to obtain the best results and storage hygiene. 1.The larder fridge is suitable for the short term storage of fresh food and drinks. 2.Cooked dishes must be stored in airtight covered containers. 3.Fresh wrapped produce can be placed on the shelf. Fresh fruit and vegetables should be cleaned and stored in the salad crisper bin. 4.Bottles can be placed upright in the door rack. 5.
STARTING Final Check CLEANING AND CARE ** We recommend that you switch off the larder refrigerator at the socket outlet and pull out the mains plug before cleaning. Before you start using the refrigerator check that: 1. The front feet have been adjusted so the appliance is level. 2. The interior is dry and air can circulate freely. 3. Clean the interior as recommended under "CLEANING AND CARE." 4. Insert the plug into the wall socket and switch on the electricity supply.
REPLACING THE INTERIOR LIGHT BULB (See diagram) Should the light fail to work switch off at the socket outlet and pull out the mains plug. Use a cross headed screw driver to remove the light diffuser cover. Then ensure the bulb is screwed in until it is secure in the bulb holder. Replace the plug and switch on. If the bulb functions, reassemble by reversing the above procedure, ensure the top cover is in place.
(17) REVERSING THE DOOR We recommend that you reverse the door before switching on for the first time. 5 Tools required: Small and medium size flat and cross-headed screwdrivers, a pair of pliers. 5 2 3 Spare Parts supplied in the plastic bag: The following parts, which are exclusively for left hand side fitted hinge operation are supplied in a plastic bag with the appliance: 1 - Door top trim hinge covers – there are 2 different parts, one for each side of top trim.
GUARANTEE DETAILS HOW TO OBTAIN SERVICE Your new Beko product is guaranteed against the cost of breakdown repairs for twelve months from the date of the original purchase. Please keep your purchase receipt or other proof of purchase in a safe place; you will need to have it should the product require attention under guarantee. What is covered? • Repairs necessary as a result of faulty materials, defective components or manufacturing defect.