User`s manual

71 / 76 EN
Washing Machine / User’s Manual
Iftheholesonthebellowshowninthefigureisblocked,
open the holes using a toothpick.
C
Foreignmetalsubstanceswillcauseruststainsinthe
drum. Clean the stains on the drum surface by using
cleaningagentsforstainlesssteel.Neverusesteelwool
orwirewool.
A
WARNİNG: Neverusespongeorscrubmaterials.These
willdamagethepaintedandplasticsurfaces.
5.3 Cleaning the body and control panel
Wipethebodyofthemachinewithsoapywaterornon-
corrosivemildgeldetergentsasnecessary,anddrywitha
soft cloth.
Use only a soft and damp cloth to clean the control panel.
5.4 Cleaning the water intake filters
Thereisafilterattheendofeachwaterintakevalveatthe
rearofthemachineandalsoattheendofeachwaterintake
hosewheretheyareconnectedtothetap.Thesefilters
preventforeignsubstancesanddirtinthewatertoenterthe
washingmachine.Filtersshouldbecleanedastheydoget
dirty.
1. Close the taps.
2.Removethenutsofthewaterintakehosestoaccess
thefiltersonthewaterintakevalves.Cleanthemwithan
appropriatebrush.Ifthefiltersaretoodirty,takethemout
by means of pliers and clean them.
3.Takeoutthefiltersontheflatendsofthewaterintake
hosestogetherwiththegasketsandcleanthoroughly
underrunningwater.
4. Replace the gaskets and filters carefully in their places
and tighten the hose nuts by hand.
5.5 Draining remaining water and
cleaning the pump filter
Thefiltersysteminyourmachinepreventssoliditems
such as buttons, coins and fabric fibers clogging the pump
impellerduringdischargeofwashingwater.Thus,thewater
willbedischargedwithoutanyproblemandtheservicelife
ofthepumpwillextend.
Ifthemachinefailstodrainwater,thepumpfilterisclogged.
Filtermustbecleanedwheneveritiscloggedorinevery3
months.Watermustbedrainedofffirsttocleanthepump
filter.
5 Maintenance and cleaning
Servicelifeoftheproductextendsandfrequentlyfaced
problems decrease if cleaned at regular intervals.
5.1 Cleaning the detergent drawer
Cleanthedetergentdraweratregularintervals(every
4-5washingcycles)asshownbelowinordertoprevent
accumulationofpowderdetergentintime.
1.Pressthedottedpointonthesiphoninthesoftener
compartmentandpulltowardsyouuntilthecompartment
is removed from the machine.
C
Ifmorethannormalamountofwaterandsoftener
mixturestartstogatherinthesoftenercompartment,the
siphon must be cleaned.
2.Washthedetergentdrawerandthesiphonwithplentyof
lukewarmwaterinawashbasin.Wearprotectivegloves
or use an appropriate brush to avoid touching of the
residuesinthedrawerwithyourskinwhencleaning.
3.Insertthedrawerbackintoitsplaceaftercleaningand
makesurethatitisseatedwell.
5.2 Cleaning the loading door and the drum
Residues of softener, detergent and dirt may accumulate
in your machine in time and may cause unpleasant odours
andwashingcomplaints.Toavoidthis,usetheDrum
Cleaningprogramme.Ifyourmachineisnotfeaturedwith
Drum Cleaningprogramme,useCottons-90programme
and select Additional Water or Extra Rinseauxiliary
functionsaswell.RuntheBeforestartingtheprogramme,
putmax.100gofpowderanti-limescaleintothemain
washdetergentcompartment(compartmentnr.2).Ifthe
anti-limescale is in tablet form, put only one tablet into
compartmentnr.2.Drytheinsideofthebellowwithaclean
piece of cloth after the programme has come to an end.
C
Repeat Drum Cleaning process in every 2 months.
C
Useananti-limescalesuitableforthewashingmachines.
Aftereverywashingmakesurethatnoforeignsubstanceis
left in the drum.
4.17 Your machine is equipped
with a “Standby Mode”
Incaseofnotstartinganyprogrammeorwaitingwithout
makinganyotheroperationwhenthemachineisturned
onbyOn/Offbuttonandwhileitisinselectionsteporif
nootheroperationisperformedapproximately2minutes
after the programme you selected has come to an end, your
machinewillautomaticallyswitchtoenergysavingmode.
Displaybrightnesswilldecrease.Incaseofrotatingthe
ProgrammeSelectionknoborpressinganybutton,lightswill
restoretotheirpreviouscondition.Thisisnotafault.