Operation Manual
14
EN
Ifyouonlywanttodrainthewaterwithoutspinning:
JustpressStart/Pause/Cancelbutton.Pausesymbol
disappears. Start symbol appears. Programme resumes and
discharges the water only.
End of programme
“End” appears on the display at the end of the programme.
Symbols of the programme steps remain lit. Auxiliary
function, spin speed and temperature that were selected at
the beginning of the programme remain selected.
Close the taps. Remove the nuts of the water intake hoses to
access the filters on the water intake valves. Clean them with
anappropriatebrush.Ifthefiltersaretoodirty,takethem
out by means of pliers and clean them. Take out the filters
on the flat ends of the water intake hoses together with the
gaskets and clean thoroughly under running water. Replace
the gaskets and filters carefully in their places and tighten
the hose nuts by hand.
Draining remaining water and
cleaning the pump filter
The filter system in your machine prevents solid items
such as buttons, coins and fabric fibers clogging the pump
impeller during discharge of washing water. Thus, the water
will be discharged without any problem and the service life of
the pump will extend.
Ifthemachinefailstodrainwater,thepumpfilterisclogged.
Filter must be cleaned whenever it is clogged or in every 3
months. Water must be drained off first to clean the pump
filter.
Inaddition,priortotransportingthemachine(eg.,when
moving to another house) and in case of freezing of the
water, water may have to be drained completely.
A
Foreign substances left in the pump filter may damage
your machine or may cause noise problem.
Inordertocleanthedirtyfilteranddischargethewater:
Unplugthemachinetocutoffthesupplypower.
A
Temperature of the water inside the machine may
riseupto90ºC.Toavoidburningrisk,filtermustbe
cleaned after the water in the machine cools down.
Open the filter cap.
Ifthefiltercapiscomposedoftwopieces,pressthe
tab on the filter cap downwards and pull the piece out
towards yourself.
Ifthefiltercapisonepiece,pullthecapfrombothsidesat
the top to open.
C
You can remove the filter cover by slightly pushing
downwards with a thin plastic tipped tool, through the
gapabovethefiltercover.Donotusemetaltippedtools
to remove the cover.
Some of our products have emergency draining hose and
some does not have. Follow the steps below to discharge
the water.
Dischargingthewaterwhentheproducthasanemergency
draining hose:
5 Maintenance and cleaning
Servicelifeoftheproductextendsandfrequentlyfaced
problems decrease if cleaned at regular intervals.
Cleaning the detergent drawer
Clean the detergent drawer at regular intervals (every
4-5washingcycles)asshownbelowinordertoprevent
accumulation of powder detergent in time.
Press the dotted point on the siphon in the softener
compartment and pull towards you until the compartment is
removed from the machine.
C
Ifmorethannormalamountofwaterandsoftener
mixture starts to gather in the softener compartment,
the siphon must be cleaned.
Wash the detergent drawer and the siphon with plenty of
lukewarm water in a washbasin. Wear protective gloves or
use an appropriate brush to avoid touching of the residues in
thedrawerwithyourskinwhencleaning.Insertthedrawer
back into its place after cleaning and make sure that it is
seated well.
Cleaning the water intake filters
There is a filter at the end of each water intake valve at the
rear of the machine and also at the end of each water intake
hose where they are connected to the tap. These filters
prevent foreign substances and dirt in the water to enter the
washing machine. Filters should be cleaned as they do get
dirty.