Instructions / Assembly

Fixture

Mounting Unit

Mounting Screws

Wire Nuts

*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE

page 1

CAUTION

Inspect the wire insulation for any cuts,

abrasions, or exposed copper that may have

resulted during shipping. If there is a defect in

the wire, do not attempt installation.

Before starting installation of this fixture or

removal of a previous fixture, disconnect the

power by turning off the circuit breaker or by

removing the fuse at the fuse box.

Flat blade

screwdriver

Canopy

Rods

Glass

pendant LIGHT

Assembly Instructions

MODEL#:11616

PAGE 1
pendant LIGHT Assembly Instructions MODEL#:11616 CAUTION Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have resulted during shipping. If there is a defect in the wire, do not attempt installation. Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box.
PAGE 2
pendant LIGHT Assembly Instructions MODEL#:11616 STEP 2 STEP 1 Use the mounting screws to attach the mounting unit to the junction box Screw the rods to the fixture. Make sure to feed the branchwires of the fixture through the rods during assembly. Remove or add rods to adjust the height. STEP 3 Make the electrical connection from the junction box to the fixture. Connect the ground wire to the mounting unit using the preinstalled green ground screw.