User Manual

22
The BE-900MHZCID has been designed to give years of trouble free service. To help insure its longevity,
please read the following maintenance instructions:
• Keep the BE-900MHZCID dry. If it gets wet, first unplug the AC adapter then wipe the unit dry immediately.
Liquids can contain minerals that can corrode electronic circuits.
• Use and store the BE-900MHZCID only in normal temperature environments. High temperatures can
shorten the life of electronic components and distort or melt its plastic parts.
• Keep the BE-900MHZCID away from dust and dirt, which can cause premature product failure.
• Handle the BE-900MHZCID gently and carefully. Dropping it can cause serious damage to circuitry, or
plastic case, which may result in causing it to malfunction.
• The BE-900MHZCID has built-in surge protection circuits that meet or exceed FCC requirements.
However, an incident such as a lightning strike at or near the telephone lines, could cause serious damage.
• If the BE-900MHZCID is installed in an area with frequent / or severe electrical storm, it is suggested that
the
telephone be disconnected during these storms or that additional surge suppression equipment be added
to the installation.
• It is the responsibility of users requiring service to report the need for service to TT Systems Corporation.
They will make the necessary arrangements for repair or replacement.
• Should you have any questions about the operation of the BE-900MHZCID, please call 1-914-968-2100,
between the hours of 9:00 A.M. and 4:30 P.M. eastern time. Or you may contact TT Systems Corporation
for technical assistance via our Internet Website: http:/[e-mail].
TROUBLESHOOTING
We do not expect you to have any problem with your phone, but if you do, the following suggestions may help.
SYMPTOM SUGGESTION
The phone does not work.
Make sure that the RINGER
ON/OFF switch is in the ON
position.
Ensure the phone's
telephone cord and the AC
adapter are installed
correctly.
Recharge the keypad's
battery pack. If the battery
power is too low, the BATT.
LOW indicator will not light.
Reset the security access-
protection code by placing
the remote keypad in the
cradle. Disconnect the AC
power and then reconnect
the AC power.
Move the remote keypad
closer to the base.
Interference is severe Move the remote keypad