User's Manual

3
Written By: Belco International Co., Ltd. PAGE: 11 of 24
2.4.4 LEDs on Base unit:
Name Description
Talk LED LED off if the phone is “on-hook”.
LED on if the phone is “off-hook”.
Distinctive and power ring cadence blinking during incoming
call ringing.
LED fast blinking if Page is pressed (hold mode)
Charge/ Page
LED
LED off if the handset is out of the cradle.
LED on if the handset is on the cradle.
LED slow blinking if Page is pressed (on-hook mode)
LED slow blinking if Page is pressed (off-hook mode)
2.5 TEST MODE:
Shall have test mode.
2.6 OPERATING PROCEDURES:
2.6.1 Handset:
The unit shall provide audible feedback when keys are depressed.
# NAME USER INTERFACE NOTE
1 TALK
Shall initiate or terminate TALK mode. Toggle between ON and
OFF hook.
When incoming call, press TALK key to accept the call.
When line is not in use, press TALK key to initiate a call.
The unit shall establish a RF link between the base and the
handset. The base shall seize the line, routing audio to and from
the handset. The TALK LED’s shall is on for the baseset and
become steadily lit for the handset respectively.
Auto ON-HOOK:
The unit shall automatically be placed on-hook when the
handset is placed in the charging cradle, or when the
handset has been determined to be Out-of-Range for a
sufficient period of time.
The unit shall be
capable of
automatically
selecting the clearest
available channel
when initiating TALK
mode.
RF link time of 1.5 sec
or less is preferable.
2 Redial/Pause
ON hook - Shall insert a pause in memory dialing sequences
being stored. Pause time shall be 2 seconds.
OFF hook – Shall redial the most recently dialed number in TALK
mode.
During the redial in
tone mode DTMF
tone will be heard
through ear-piece.
3 Channels
Automatic Channel Change – The unit shall be capable of
automatically selecting the clearest available channel.
No voice muting.