User's Manual

3
Written By: Belco International Co., Ltd. PAGE: 9 of 24
2.3.2.2 Handset unit
When the base incoming call will be flash LED and heard beep tone
on handset.
2.3.2.3. Page ring:
This ring will alert the other party to page H/S from B/U for 15seconds.
The page function will operate the ringer of H/S only. This ring shall be
distinctive from incoming call ring.
In case that the handy is low battery or in the out-of range where the
handy is not capable of recieving ID handshake command the base unit
sends, The base unit stops sending the paging data only for 2 seconds.
Time (ms) ON 80 80
Time (ms) OFF 80 730
Beep Frequency (kHz) 2048 2048
2.3.3. Tone Feedback on Key Press
When the base or handset accepts key inputs, appropriate feedback shall be
produced by handset. All feedback tones shall be the same frequency of 2.0 kHz ±
10%.
Tone feedback shall be heard during temporary tone action in pulse mode.
2.3.3.1. Key Tone:
Shall be produced in response to most accepted key presses.
Cadence
Beat 1
Time (ms) On 80
Time (ms) Off ---
2.3.3.2. Confirmation Tone
Shall be produced when a key press is accepted, completing a complex
sequence and altering nonvolatile stored information, such as configuration
settings and repertory dialing entries.
Cadence
Beat 1 2
Time (ms) ON 80 80
Time (ms) OFF 80 --