User manual
45
7 Turn the blue gear wheel forward to tension the ink
film. The ink film must not have any creases.
8 Close the device. Insert the paper tray in the opening
provided for it behind the paper feeder. Insert paper
again.
Using Service Codes
The function 45 (service codes) deletes all the changed set-
tings and your device is reset to factory settings. This can
be useful, when settings have been changed and some fea-
tures do not work as expected.
1 Press OK, 45 and OK.
2 Enter a service code:
7117 – Deletes all changed settings and saved data.
The device is reset to factory settings and the initial instal-
lation process is started.
7140 – Deletes all changed settings. Saved data and
telephone book entries remain intact.
7227 – Deletes saved faxes, when there are problems
with printing.
3 Confirm using OK.
4 Use [ to select
SURE: YES.
5 Confirm using OK.
Power Cycling
If a problem occurs that cannot be corrected with the in-
structions in this user manual (see also the help below), fol-
low the steps given here.
1 Pull out the power plug.
2 Wait at least ten seconds, then plug the power plug
back into the socket.
3 If the error occurs again, please contact Belgacom.
Only use this function if this is absolutely necessary.
If you have entered the incorrect code, you can
cancel the entry with
SURE: NO.
General information
The time and date flash on the display. You must check the time and date after a short power fail-
ure. Confirm using OK.
Problems when faxing or printing
Faxes sent are of poor quality.
Change the resolution from
RESOL.: STANDARD to
RESOL.: FINE or RESOL.: PHOTO.
Change the contrast.
Clean the scanner.
Test the device by making a copy of the document. If the
device is in order, the fax machine of the recipient is defec-
tive.
The device produces black lines when sending or printing. Clean the scanner and the document feed slot.
Copy is blank. Insert the documents face up into the document feeder.
Printing is interrupted. Paper or document jam, no paper or ink film. Follow the
instructions on the display and in the error report.
There could be a small pause after printing several pages.
The device continues printing automatically.