User manual

46
No printing Check if you have inserted clamped paper correctly. The le-
ver on the right hand side next to the paper feeder must be
folded backwards.
Documents are not properly fed. Clean the scanner.
Problems when faxing or printing
Problems with the connection
The device rings once, remains silent for a short while and
starts ringing again.
This is absolutely normal. The fax switch checks the call af-
ter the first ring. If it is a voice call, the device continues to
ring.
No dial tone Check the installation of the device. Connect the telephone
cable to the socket marked LINE. Insert the telephone plug
into your telephone connection socket.
Fax transmissions are constantly interrupted. Try to send the fax manually: Press l and dial the number.
If the recipient is using an answering machine, wait until
you hear a whistling tone. Press o.
It is possible that the recipient's machine is not ready to re-
ceive.
You hear a whistling tone or silence in the handset. The call is a fax: Press o on the device. In addition, press
*5 on the telephone. Hang up.
No fax reception Using function 51, set the number of rings (see page 35).
You cannot simultaneously use the PhoneMail function
and receive faxes (see page 39).
Problems with the Cordless Telephone
Cordless telephone does not function or does not function
as expected.
Display shows only the battery charge.
Check if the cordless telephone is functioning and is regis-
tered with the device.
Switch the cordless telephone off. Open the battery com-
partment on the backside. Remove the batteries and insert
them again. Close the battery compartment and switch the
cordless telephone on again.
No dial tone The cordless telephone is not registered with the device or
is out of range.
The cordless telephone cannot be switched on. Place the cordless telephone into the charging station.
The cordless telephone cannot be switched on after 12
hours in the charging station.
Change the batteries in the cordless telephone (also see
Chapter Service, Page 42).