Belgacom Maestro 1045 2_Manuel_Maestro1045.
Table of contents Table of contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Contents of the box . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Overview of the Maestro 1045 . . . . . . . . . . . . . . . . . . . . . . . 4 Installing the telephone . .
Introduction Thank you for choosing the Belgacom Maestro 1045, a telephone that can be used at home and in the office. This telephone has been designed for connection to the analogue telephone network of Belgacom.
Contents of the box We advise you to check the contents of the box before installing the telephone. These are the contents: Receiver Telephone base Line cord 5-pin plug Coiled cord – 2 screws and 2 plugs – User manual If you find that any of the parts are missing, please return the telephone in its box to the Teleboetiek shop, and show your receipt.
Overview of the Maestro 1045 Receiver Earpiece Suspension point on receiver for wall mounting Microphone (mouthpiece) Connection for coiled cord Telephone base, top Receiver contact Suspension clip on receiver for wall mounting Microphone off/on R Flash key (switch between conversations, call waiting, put through) Last number redial
Telephone base, side Sound level switch Telephone base, underside Suspension section with suspension points for wall mounting Cord guide for line cord Connection point for line cord Connection point for coiled cord Ring tone volume switch: high/low Cord guide for coiled cord
Installing the telephone Safety instructions - Do not use the telephone in humid or dusty conditions, a gas-logged environment or an environment in which the telephone would come into contact with water. - Do not expose the telephone to sunrays or other heat sources. - Do not place the telephone on a slippery or unstable surface, and place it at least one metre away from any other devices that may cause interference, such as wireless devices, pagers, TVs, industrial devices, etc.
3 Guide the cords through the cord guides at the bottom of the telephone base. 4 Plug the 5-pin plug into the telephone socket. 5 Pick up the receiver and check for a dialling tone. > The telephone is now ready for use. Mounting the telephone on the wall 1 Use a screwdriver to turn the suspension clip in the receiver holder on the telephone base. This will make part of the clip stick out (picture 1). The receiver will be suspended from the clip.
> You will hear a click to indicate it has come loose. A B Picture 2: remove suspension section 5 Turn the section over and place it in the slots in the centre of the telephone base (picture 3). > You will hear a click to indicate it is secured. Picture 3: attach suspension section 6 Now carefully slide the suspension points of the telephone base across the 2 screws until the base is properly secured, and place the receiver (picture 4).
Making calls Making calls 1 Pick up the receiver and wait for the dialling tone. 2 Enter the telephone number. Accepting an incoming call > The telephone starts ringing. 1 Pick up the receiver to answer the call. Disconnecting 1 Place the receiver back on the telephone base, or press the receiver contact. Last number redial 1 Pick up the receiver and wait for the dialling tone. 2 Press . The number you dialled last will be dialled again.
Personal settings Setting the ring tone Use the switch on the bottom of the telephone base to change the ring tone volume to high or low. Setting the volume Use the switch on the right side of the telephone base to change the receiver’s sound level during a call (3 settings).
Troubleshooting What to do in the event of malfunctions If there is no dialling tone or if you are unable to make a call, follow the instruction given below: 1 Check whether the telephone has been installed correctly (see page 6). 2 Check for damage to the line cord. 3 Disconnect all peripheral equipment, extension leads and other telephones and test the Maestro 1045 directly on a different telephone line, which you know to be in working order.
Repairs If you are unable to solve the problem, you can take the entire telephone set to a Teleboetiek shop. Also bring the completed warranty card and your receipt if the telephone is still within its warranty period. You can also call Belgacom customer services. Recycling Natural resources were tapped and used for the production process of the telephone you have purchased. This equipment may contain substances that are harmful to your health and the environment.
Technical details Dimensions 190 x 78 x 85 mm Ring tone Adjustable volume Weight 415 grams Dialling method Tone dialling Network The Maestro 1045 functions on the analogue network (PSTN) of Belgacom.
Declaration of comformity 14
Guarantee terms The Equipment you have bought has been carefully selected by Belgacom and is covered by a two-year warranty on spare parts and labor in the event of any material or manufacturing defect, unless otherwise specified. The warranty shall be valid from the date on which the equipment is collected or delivered.
- the repair or replacement of movable parts (cords, wires, plugs, aerials, etc.), consumables (cells, batteries, paper, ink, etc.) needing regular replacement and the supply of cleaning products.
Guarantee certificate Please keep in a safe place Device: Serial number: Date of purchase, replacement or repair (*) Name and address of the buyer: Telephone number of the relevant technical department: Stamp: (*) Please delete as appropriate 17
18
Wall mounting 19