Brochure

800-543-9038 USA 866-805-7089 CANADA 203-791-8396 LATIN AMERICA

5-11

PC-Tool User Manual

for SY-MFT Series Actuators

4 Controller simulation

Go to the "Simulation" tab.

"Simulation" tab for SY-MFT actuators

The controller simulation is not possible while the actuator is performing an adaptation or

synchronization.

4.1 Actuator control

Select the type of setpoint definition with the radio buttons.

 Setpoint Y (only available in PP mode): Control signal at connection Y according to selected

control type (DC, PWM, open/close, 3-point).

 Setpoint Tool (not available with control type open/close or 3-point): The setpoint is entered

in % of the programmed range. 0% is the minimum, 100% the maximum. The input values

are converted and displayed in the units of the corresponding control signal (volts or

seconds).