Brochure

800-543-9038 USA 866-805-7089 CANADA 203-791-8396 LATIN AMERICA

1-23

PC-Tool User Manual

NOTE: USE THIS SECTION ONLY IF THE ACTUATORS (S) MP ENABLED.

3.4.1 Series addressing of actuators

Click the Address device icon in the toolbar [B].

Option Click the MP-Channel with the right mouse button and select Addressing Device. Or select MP-

Channel ` Addressing Device in the main menu.

Series addressing

If one of the addresses is already assigned to another actuator, a message will be displayed:

Message when an address is already assigned (series addressing)

Click Yes to initially release the address. The actuator that used to occupy the address is set to PP.

If you select No, the actuator will be set to the already assigned address and a bus jam can occur.

Click Cancel to stop the series addressing at this point. You can now rearrange the addresses or

end the entire process.